Jump to content
Electronics-Lab.com Community

Kevin Weddle

Members
  • Posts

    1,620
  • Joined

  • Last visited

  • Days Won

    1

Kevin Weddle last won the day on August 12 2018

Kevin Weddle had the most liked content!

1 Follower

About Kevin Weddle

  • Birthday 02/17/1974

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Kevin Weddle's Achievements

Newbie

Newbie (1/14)

2

Reputation

  1. I think at 1Khz, the capacitor could not completely charge in one cycle. No, that's not it. You have to make the resistance higher than the impedance of the capacitor.
  2. .
  3. fkf ukhuyjhvfrtrfv
  4. Something I noticed about voltage multipliers. I've never seen two equally charged capacitors reverse bias a diode. But as long as the capacitors are completely charged the diode is reverse biased.
  5. I know there is a simpler 15V to 45V voltage multiplier than the one I posted. It might be adequate. I won't bother posting that one.
  6. Wow this Windows 10 is great.
  7. Thanks guys. I love to hear you.
  8. They always conduct. No matter what. These two circuits are different. Resistors don't clamp a voltage. The voltages halve, halve, and halve again until Vp. ac.pdf
  9. The other equation is Xc - Xl. So a series LRC is only inductive or capacitive.
  10. In the quation v = L di/dt. The voltage goes up and the current goes up. In the equation i = C dv/dt. The voltage goes up and the current goes up.
  11. The only addition I'll add to my post is the current of the capacitor must at least be C dv/dt.
  12. Capacitor's pull current through a resistance. Then you have voltage momentarily.
  13. I went ahead and built this circuit today. The input resistor voltage changed very little. The output transistor voltages changed quite a bit.
  14. The schematic shown has a gain of 10. I changed the gain to 10,000 in this circuit. I don't know how unstable that would make it. I guess I'll have to match the opamp and output transistors.
  15. It is versatile.
×
  • Create New...