Jump to content
Electronics-Lab.com Community

admin

Administrators
 View Profile  See their activity

  • Posts

    182

  • Joined

  • Last visited

  • Days Won

    5

admin last won the day on June 3 2020

admin had the most liked content!

2 Followers

About admin

Contact Methods

  • Website URL
    http://www.electronics-lab.com

Profile Information

  • Gender
    Male

Recent Profile Visitors

32,703 profile views

admin's Achievements

Apprentice

Apprentice (3/14)

  • First Post Rare
  • Collaborator Rare
  • Conversation Starter Rare
  • Dedicated Rare
  • Week One Done Rare

Recent Badges

11

Reputation

  1. admin
    I also experienced issues with long cables and bought a short one to test. Although the long cable worked, I often needed to disconnect and connect it again to get the Arduino programmed, and though it was some connection issue, but seems it's the cable length that affected the signal. I will give it a try on the short cable and confirm the issue.
  2. admin
    Have you got issues with long USB cables? Like disconnections and errors?
  3. admin
    Thanks for sharing your schematic. Could you give us a little more info on what this does?
  4. stra57

    Dear Sir,

    I would like your help.
    I am looking for a circuit diagram with a PCB that would rotate the motor shown in the picture at 33 and 45 revolutions.
    you need a quartz precision controller and a digital display that shows the real speed with the Hall sensor mounted on the motor shaft.

    Best Regards

    Andrew

     

    20231209_121853.jpg

  5. lev jeysel started following admin
  6. admin
    admin changed their profile photo
  7. mlaiskuwu

    hello

     

  8. admin
    Sure, and a few additional information as well will be perfect.
  9. admin
    Hi there, a well designed logic probe is always welcome by hobbyists. Could you publish a preview?
  10. admin
    glad to hear that it worked for you.
  11. admin
    I've cleared the server cache, do the same to your browser and try once more, please.
  12. admin
    Can you confirm that the MIC polarity is correct? Also, check that you have adjusted the potentiometers to a low setting, while set them to a high level may saturate the amplifier.
  13. htelec.net started following admin
  14. admin
    oh, what a find. I still have the old website on my archive! Here is the old homepage. What did you liked most on the old website ?
  15. admin
    ok then , use a 1.5mm^2 wire for 12V/5A source.
  16. admin
    Wire gauge is important for the amount of current it can carry without significant heating. If you are going to pull much current from the power supply then you need thick wires, otherwise normal gauge will work.
  17. admin
    What would you like to do ? Solder them ?
  18. admin
    Hi, Thanks for pointing us to this. We are working to make it work like you said. For now you can see your username when logged in. We will make this site wide the following days. Best,
×
×
  • Create New...